,

Brake Box Gasket (ZKB65-306-010)

Brake box gasket for the ZKB85 gearbox. Part ZKB65-306-010. In-stock replacement for the FM WORLD 4LZ-6.0P (ZKB85) gearbox.

Brake Box Gasket (ZKB65-306-010) for the FM WORLD 6.0P

The gasket that seals the brake box cover on the ZKB85 gearbox group, 170 mm outside diameter and 1 mm thick, 0.01 kg. It is the cheapest part in this batch and the one that decides whether the brake side stays dry.

Specifications

Part NumberZKB65-306-010
Part TypeBrake box gasket
Outside Diameter170 mm
Thickness1 mm
Weight0.01 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

What this part does

A gasket has one job: hold the joint closed across its whole face. On the brake box that matters twice, because the box holds oil for the brake and steering clutch and sits where dust and chaff collect. A gasket that has hardened, split, or been over-compressed leaks oil out and lets water in, and water in a brake pack is what glazes the friction faces and makes the steering grab.

Reusing a gasket and fitting a new one

An old gasket that looks intact has already been compressed once; it will not take the same set twice, and the leak usually appears within a few weeks of the rebuild. Because this part costs almost nothing next to the labour of opening the box again, a new gasket belongs in every rebuild, even when the old one comes off in one piece.

Fitting notes

Remove the old gasket completely, including any that has stuck to the face, and clean both faces dry before fitting. Fit the gasket so it lies flat with no wrinkle and no stretched edge, then tighten evenly around the cover. Check the cover face for a step or a scrape from an earlier repair, since a damaged face will leak through a new gasket.

Before you fit it

Scrape and clean both faces, then look for a step where a previous repair cut into the surface. A new gasket will not seal over a scored face.

Signs it needs replacing

  • Oil film or drip at the brake box joint
  • Gasket hardened, cracked, or stuck to one face on removal
  • Water or chaff found inside the box at inspection
  • Steering that grabs after the box has been in wet field conditions

Compatibility and cross reference

Models covered

Brake box joint on the ZKB85 gearbox group of the FM WORLD 4LZ-6.0P (Ruilong). ZKB65-306-010 is the gasket that sits under that cover.

Confirming the right part

Confirm ZKB65-306-010 on 170 mm outside and 1 mm thickness, and lay the old gasket over the new one to compare the port pattern.

Reading the old part

This gasket usually carries no readable marking at all. Identify it by 170 mm outside, 1 mm thickness and the port pattern, and compare the old gasket over the new one before fitting.

Questions we are asked about this part

Is it worth replacing a gasket that looks fine?

On this box, yes. It is a low-cost part and the labour to open the box again is the real expense, and a compressed gasket rarely seals a second time.

What happens if water gets into the brake box?

It glazes the friction faces and the steering starts to grab or slip. If water is found, the pack needs to be inspected rather than just resealed.

Related parts