Pressure Plate (ZKB75-303-009) for the FM WORLD 6.0P
A flat plate from the steering clutch pack inside the ZKB85 box: 120 mm outside, 80 mm bore, 3 mm thick, 0.15 kg. It is one of the thin parts of the pack, and it is the surface that presses the friction disc against its mating face.
Specifications
| Part Number | ZKB75-303-009 |
|---|---|
| Part Type | Pressure plate (clutch pack) |
| Bore | 80 mm |
| Outside Diameter | 120 mm |
| Thickness | 3 mm |
| Weight | 0.15 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
| Availability | In stock, ready to ship |
What this part does
In a steering clutch pack the pressure plate is the part that turns lever movement into friction. It has to sit flat against the disc and press evenly, so what matters is not its strength but its flatness: a plate that has warped or been heat-marked presses on one side and lets the other side slip. On a harvester that shows up as a track that drags when it should be free, or one that loses drive when the pack heats up.
Pressure plate and friction disc are not the same wear story
The friction disc wears by losing thickness across its whole face, which is gradual and even. The pressure plate wears by taking heat and distorting, which is local and uneven. Fitting a new disc behind a warped plate brings the same drag back within a season, so the pair should be checked together rather than the disc alone.
Fitting notes
Lay the plate on a straight edge and check it for flatness before fitting; 3 mm leaves little room for distortion. Clean the pack faces and confirm the plate sits square in its housing, then set the clutch adjustment from the service manual rather than from feel, since an over-adjusted pack is what warps the next plate.
Before you fit it
Check the mating face of the housing as well as the plate. A scored housing face will warp a new plate in the same way the old one was warped.
Signs it needs replacing
- Track drags or chatters with the steering lever released
- Steering that works cold and slips once the box is hot
- Heat discolouration or blue marks on the plate face
- Plate no longer flat when laid on a straight edge
Compatibility and cross reference
Models covered
Steering clutch pack inside the ZKB85 gearbox on the FM WORLD 4LZ-6.0P (Ruilong). ZKB75-303-009 is the plate number; other plates in the pack are thicker.
Confirming the right part
Confirm ZKB75-303-009 on 120 mm outside, 80 mm bore and a measured 3 mm thickness. Thickness is the figure that separates this plate from thicker clutch parts.
Reading the old part
A plate this thin rarely keeps a legible stamp. Identify it by 120 mm outside, 80 mm bore and a measured 3 mm thickness rather than by any marking.
Questions we are asked about this part
The plate is only 3 mm thick. Is that normal?
That is the listed thickness for this part, and it is why flatness matters more than strength. A plate of this thickness that has taken heat will distort before it cracks.
Must the friction disc be replaced at the same time?
Check it. If the disc is still full thickness and unglazed it can stay, but a worn disc against a new plate wears the plate unevenly in the other direction.




