Idle Shaft (ZKB80-304-001) for the FM WORLD 6.0P Gearbox
The idle shaft is 190 mm long with a 40 mm diameter and weighs 1.8 kg. It is a stationary shaft: the idler gear turns on it rather than turning with it, which is why it carries no spline and why its wear shows as a polished band rather than a broken tooth.
Specifications
| Part Number | ZKB80-304-001 |
|---|---|
| Part Type | Idle shaft, stationary |
| Length | 190 mm |
| Diameter | 40 mm |
| Weight | 1.8 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
| Availability | In stock, ready to ship |
What this part does
Because the shaft does not rotate, load always lands on the same area of its surface. The idler gear’s bearing turns around that band for the whole life of the box, and the surface there slowly polishes, then frets, then wears down. A drop of even a few hundredths of a millimetre opens the fit, the idler starts to run with a little tilt, and the mesh with its neighbours changes. That is heard as a new whine that appears only when the idler is loaded, and it is often blamed on the gears themselves.
Idle shaft and the gear that runs on it
The two parts fail in sequence. The shaft wears a band where the bearing sits, and the idler bearing wears to match it. Replacing the shaft alone against a bearing that has already opened up leaves the same clearance, and replacing the bearing alone against a worn shaft does the same. Measure both: the shaft at 40 mm on its worn band, and the idler bore at its running position.
Fitting notes
Check the 40 mm diameter on the worn band rather than at the ends, because the ends stay original while the middle wears. Confirm the shaft seats square in its housing and cannot rotate, then check the idler turns freely on it with no tight spot. End play and the retaining arrangement follow the service manual.
Before you fit it
Measure the worn band with a micrometer, not with a caliper across the ends. A shaft that reads 40 mm at each end can still be 39.9 mm where the bearing actually runs.
Signs it needs replacing
- New whine that appears only with the idler loaded
- Polished, fretted or stepped band where the idler runs
- Idler that can be tilted on the shaft by hand
- Metal particles in the oil without any broken teeth
Compatibility and cross reference
Models covered
The idle shaft belongs to the 304 group of the ZKB85 box on the FM WORLD 4LZ-6.0P, where the idler gear turns on it. The idler itself is ordered separately.
Confirming the right part
Confirm ZKB80-304-001 on 190 mm length and 40 mm diameter. A shaft of the same diameter but a different length will not line up with the idler position.
Reading the old part
The number is stamped on the shaft end, which is usually the only part still clean. Measure 190 mm overall and 40 mm at the running band, not at the ends.
Questions we are asked about this part
Should I replace the shaft when I replace the idler gear?
Measure first. If the running band is still 40 mm and unmarked, the shaft can stay; if it has worn a step, a new idler on it will run loose and the noise returns.
Is the shaft the same as a gear shaft?
No. This shaft is stationary and carries no spline; the gear shafts in the same box are splined and turn with their gears. At 190 mm long and 40 mm diameter it is identified by those two figures.





