,

External Shaft Ring ZKB80-303-005

Thin external ring retaining the steering gear axially. Part ZKB80-303-005. In-stock replacement for the FM WORLD 4LZ-6.0P (ZKB85) gearbox.

External Shaft Ring (ZKB80-303-005) for the FM WORLD 6.0P

This external shaft ring is a thin retaining ring that sits in a groove and stops a part walking along the shaft. It measures 40 mm inside, 50 mm outside and 2.5 mm thick, and weighs 0.01 kg. Its number belongs to the 303 group, the same group as the steering gear it retains.

Specifications

Part NumberZKB80-303-005
Part TypeExternal shaft ring, axial retainer
Inside Diameter40 mm
Outside Diameter50 mm
Thickness2.5 mm
Weight0.01 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

What this part does

At 2.5 mm thick this ring carries an axial load and nothing else, so its failure is quiet until it lets go. It holds the steering gear in position on its shaft; once the ring is worn thin, flattened or partly out of its groove, the gear starts to creep axially under load. The first symptom is usually a steering complaint rather than a noise: the clutch pack clearance closes up on one side and the machine begins to steer unevenly.

A worn ring and a missing ring look different in service

A ring that is still in its groove but worn thin shows as lost axial clearance and a gear that moves slightly under load. A ring that has come out altogether lets the gear walk until it touches something, and the damage becomes visible on the housing. Either way the check is the same: look at the groove, measure the ring at 2.5 mm, and confirm the gear cannot be shifted along the shaft by hand.

Fitting notes

Use a proper ring pliers and open the ring only as far as needed, because a ring spread too wide stays distorted. Clean the groove of debris and confirm the ring seats all the way round rather than sitting on a burr, then check the retained part for axial play by hand. Anything that adjusts the clearance behind the gear follows the service manual.

Before you fit it

Inspect the groove before fitting a new ring. A groove that has been worn wider will not hold a new ring, and the part will walk again within a season.

Signs it needs replacing

  • Axial play in the steering gear that can be felt by hand
  • Ring flattened, thinned, or sitting proud of its groove
  • Steering that changes with load on one side
  • Scuff marks on the housing where a part has been walking

Compatibility and cross reference

Models covered

The ring sits in the 303 group of the ZKB85 box on the FM WORLD 4LZ-6.0P, where it retains the steering gear axially. The steering gear itself is a different number in the same group.

Confirming the right part

Confirm ZKB80-303-005 on 40 mm inside, 50 mm outside and 2.5 mm thickness. Rings of the same diameter in a different thickness belong to other grooves.

Reading the old part

A ring this thin rarely keeps a marking. Measure 50 mm outside and 2.5 mm thickness, and check that it seats in the groove rather than standing proud of it.

Questions we are asked about this part

Can a plain circlip from a hardware shop replace it?

Not safely. The ring is 40 mm inside, 50 mm outside and 2.5 mm thick with a specific groove fit; a clip of the same diameter but different thickness will either not seat or will not carry the thrust.

Is the ring reusable after inspection?

If it is still flat, still 2.5 mm at its thinnest point and seats fully in the groove, yes. Once it has been spread wide or worn thin it will not hold the gear, and reusing it only postpones the steering fault.

Related parts