Collar (ZKB65-305-008) for the FM WORLD 6.0P Gearbox
This collar is 20 mm bore, 60 mm outside and 10 mm thick, weighing 0.2 kg. It sits in the 305 group, the steering section of the ZKB85 gearbox, and its wide, thin shape tells it apart from the spacer collar on the Gear III shaft, which is 32 mm bore and 25 mm long.
Specifications
| Part Number | ZKB65-305-008 |
|---|---|
| Part Type | Collar, steering section |
| Bore | 20 mm |
| Outside Diameter | 60 mm |
| Thickness | 10 mm |
| Weight | 0.2 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
| Availability | In stock, ready to ship |
What this part does
A collar with a 60 mm face and only 10 mm of thickness works as a shoulder, not as a spacer. Its broad face gives a bearing or a cover something flat to sit against, and its 20 mm bore locates it on a small shaft. When the face wears, the part it supports is no longer square: the symptom is a seal that leaks, or a cover that will not sit flat no matter how the bolts are tightened.
Two collars, two jobs, one gearbox
ZKB65-305-008 is 20 / 60 / 10 mm and sits in the steering section; ZKB60-302-005 is 32 / 40 / 25 mm and spaces Gear III. Both are called collars in the parts list and both look like plain rings in a photograph. Only the three measurements separate them reliably, so measure rather than matching by name.
Fitting notes
Check the broad face for scoring and the bore for fretting before fitting, and confirm the shaft it locates on has no step at the seat. Fit it flat and check with a straight edge that the face is square to the shaft, because a collar that sits on a burr tilts everything above it. Seal and cover torque figures follow the service manual.
Before you fit it
Check the seat on the shaft, not just the collar. A burr or a step under the collar tilts it, and the leak returns even with a new seal.
Signs it needs replacing
- Seal leaking at a joint that has been resealed twice
- Cover that will not sit flat or keeps loosening
- Scored or dished face on the wide side of the collar
- Collar that rocks on its seat when pressed by hand
Compatibility and cross reference
Models covered
The collar sits in the steering section of the ZKB85 box on the FM WORLD 4LZ-6.0P, under the cover. The spacer collar on the Gear III shaft is a different part in a different group.
Confirming the right part
Confirm ZKB65-305-008 on 20 mm bore, 60 mm outside and 10 mm thickness. The 32 / 40 / 25 mm collar of the same box is a different number.
Reading the old part
Collars carry no reliable stamp once they have been in oil. Measure 60 mm outside and 10 mm thickness, and check the bore at 20 mm, before comparing it with the gear shaft collar.
Questions we are asked about this part
Is this the same collar as the one on the gear shaft?
No. The gear shaft collar is 32 mm bore, 40 mm outside and 25 mm long; this one is 20 mm bore, 60 mm outside and 10 mm thick. Different group, different job.
Can a worn collar be faced off and reused?
Only if the reduction in thickness is acceptable for the cover or bearing above it. Facing changes the stack height, so the part above no longer sits where it was designed to.





