,

Roller Bearing KRV22

Small roller bearing in the gearbox control linkage. Part KRV22. In-stock replacement for the FM WORLD 4LZ-6.0P (ZKB85) gearbox.

Bearing KRV22 for the FM WORLD 6.0P Gearbox Linkage

KRV22 is a small roller bearing with a 10 mm bore, a 22 mm outside diameter and a 12 mm width, weighing 0.05 kg. In the ZKB85 gearbox it carries a pivoting or sliding member of the control linkage rather than a gear shaft, which is why it is so much smaller than the shaft bearings around it.

Specifications

Part NumberKRV22
Part TypeRoller bearing, control linkage
Bore10 mm
Outside Diameter22 mm
Width12 mm
Weight0.05 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

What this part does

A bearing this small fails for a different reason than a shaft bearing. It does not carry heavy load or high speed; it carries a small oscillating movement, often through a fraction of a turn. That means it spends its life sitting in one position, and the grease inside it never redistributes. Water and dust that reach it stay in the same spot, the race frets, and the bearing develops a notch that is felt as a click in the lever rather than heard as a rumble.

Why the small bearing is often missed

When a shift lever feels stiff or notchy, the natural suspicion goes to the fork and the rail, which are bigger and easier to see. KRV22 hides inside the linkage and is usually examined last. If the lever clicks at one point of its travel and the fork and rail check out clean, this bearing is the next item to inspect: 10 mm bore, 22 mm outside, 12 mm wide is enough to identify it on the bench.

Fitting notes

Press on the inner ring only, never on the outer ring or on the roller cage, because 0.05 kg of bearing will deform if the force goes through the wrong race. Clean the pin it runs on and check that pin for a worn flat before fitting, then confirm the linkage moves through its full travel without a tight spot. Any preload or adjustment at the lever end follows the service manual.

Before you fit it

Check the pin as carefully as the bearing. A pin worn into a flat will notch a new bearing within a season, and the symptom returns exactly where it was before.

Signs it needs replacing

  • Lever or pedal that clicks at one point of travel
  • Notchy feel with no noise at working speed
  • Grease pushed out and dirt packed on one side of the bearing
  • Visible fretting marks or a dark band on the outer ring

Compatibility and cross reference

Models covered

KRV22 sits in the control linkage of the ZKB85 box on the FM WORLD 4LZ-6.0P. It is not a shaft bearing: the shaft bearings in this gearbox are larger and carry their own numbers.

Confirming the right part

Confirm KRV22 on 10 mm bore, 22 mm outside and 12 mm width together. A bearing of the same outside diameter with a different bore will not fit the pin.

Reading the old part

At this size the number is laser-marked on the outer ring and is easy to lose under grease. Measure 22 mm outside and 12 mm width, and check the bore at 10 mm before ordering.

Questions we are asked about this part

Is KRV22 a gearbox shaft bearing?

No. At 10 x 22 x 12 mm it is far too small for a gear shaft and belongs to the control linkage. The shaft bearings in this box are larger and carry a different part number.

Can I match it by dimensions alone?

Dimensions 10 / 22 / 12 mm are the practical check, but also confirm the part number KRV22, since small bearings of similar size with different internal clearance are used elsewhere on the machine.

Related parts