Header Hydraulic Cylinder (550 mm) for FM WORLD 4LZ-6.0P
This 7.85 kg header cylinder with a 54 mm barrel and 35 mm rod raises the header and holds it at the working height.
Header cylinder data
| Drawing number | W3.5-05-01-00ML |
| Component | Header hydraulic cylinder |
| Overall length | 550 mm |
| Barrel outer diameter | 54 mm |
| Rod diameter | 35 mm |
| Mass | 7.85 kg |
| Machine | FM WORLD 4LZ-6.0P (Ruilong) |
Lifting the header
This cylinder turns oil pressure into the straight force that raises the header, and it has to hold the header up without drifting.
How the two header cylinders differ
The second header cylinder is slimmer with a thinner rod, while this one has the larger 54 mm barrel and 35 mm rod for the heavier load.
Mounting the lift cylinder
Mount the cylinder on its two pin eyes, fit the pins and clips, and connect the oil ports without letting dirt enter.
Run the header up and down a few times and then leave it raised to see that it stays in place.
Faults that end its service
- Oil leaking from the rod seal
- Rod scored, pitted or bent
- Header slowly sinking from internal leakage
- Pin eyes worn into ovals
- Seals hardened and cracked
- Barrel dented or damaged
Checks before ordering
Mounting: Header lift cylinder of FM WORLD 4LZ-6.0P (Ruilong) harvesters.
Confirmation: Send the drawing number and note the 550 mm overall length.
Dimensions to match: Compare the 54 mm barrel and 35 mm rod with the cylinder being replaced.
The other header and unloading cylinders
Buyer questions answered
What does it move?
It raises and holds the header at the set height.
Why might the header sink?
Worn piston seals let oil pass inside, so the header slowly drifts.
Identification of W3.5-05-01-00ML before ordering
Choose this cylinder when the seals leak, the rod is damaged or the header drifts; if the existing one holds and stays dry, it can remain.





