,

Guide Rail Weld, Front (W2.5D-03-32-00)

front guide rail weld for the track run. In-stock replacement for the FM WORLD harvester. Order by part number; contact us for exact fitment.

Guide Rail Weld, Front W2.5D-03-32-00 — 595 x 35 x 55 mm

The front guide rail for the FM WORLD 4LZ-6.0P track frame, 595 mm long, 35 mm in section, 55 mm high with a 30 mm rail face, and 4.7 kg. It is the shorter of the two rails on this machine and covers the front section of the frame.

Specifications

Part numberW2.5D-03-32-00
TypeFront guide rail weld
Length x section x height595 x 35 x 55 mm
Rail face height30 mm
Weight4.7 kg
FitsFM WORLD 4LZ-6.0P (Ruilong) Combine Harvester
AvailabilityIn stock, ready to ship

What this part does

A guide rail is a welded slide, not a rotating part: it has no bearing to fail and it wears instead. The belt’s return run travels along the 30 mm rail face, and that face is what keeps the run in line with the frame. Once it wears hollow or a corner is knocked off, the belt is steered sideways and starts to ride the edge of the rail rather than the face.

The 595 mm front rail against the 640 mm rear rail

This front rail is 595 mm long in a 35 mm section and weighs 4.7 kg. The rear rail WD.4FE.33 is 640 mm long, 45 mm in section and 4.4 kg. Both use a 30 mm rail face but they cover different parts of the frame, so the length and section are what separate them when the old rail has lost its markings.

Fitting notes

Mount the rail on clean frame faces and check it sits flat and parallel to the belt line before tightening. Because the belt slides directly on the 30 mm face, the rail has to be straight along its length; a rail pulled down onto a burr or a raised weld will steer the belt even when it is new. Confirm the running clearance against the service manual.

Before you fit it

Run a straight edge along the frame face and check for weld build-up or burrs, since the rail has to bed flat to steer the belt correctly.

Signs it needs replacing

  • The 30 mm rail face worn hollow or grooved by the belt
  • A corner or end broken away so the belt catches as it passes
  • The rail bent or pulled down out of line with the frame
  • The belt riding the edge of the rail instead of its face

Compatibility and cross reference

Models covered

Belongs to the FM WORLD 4LZ-6.0P Ruilong front position. The rear position takes WD.4FE.33, so fit by position and part number.

Confirming the right part

Match W2.5D-03-32-00 at 595 mm long and 35 mm section. The 640 mm rear rail is a different part.

Reading the old part

Length is the first check: 595 mm from end to end. The number itself is welded small on the rail body and is often buried under paint.

Questions we are asked about this part

Does a guide rail have any bearing or bushing inside it?

No. It is a welded slide with no rotating parts. Its only wear surface is the rail face the belt runs on, which is 30 mm high on this part.

Related parts