,

Driving Chain Wheel (WD.4MC.2-01C)

track drive sprocket, 8 teeth. In-stock replacement for the FM WORLD harvester. Order by part number; contact us for exact fitment.

Driving Chain Wheel WD.4MC.2-01C — 250 mm, 8 Teeth

The drive sprocket that pulls the track on the FM WORLD 4LZ-6.0P Ruilong. It measures 250 mm on the outside diameter with a 42 mm bore on the final drive shaft, 8 teeth of 36 mm face width, a 60 mm overall height and a weight of 6.1 kg.

Specifications

Part numberWD.4MC.2-01C
TypeTrack drive sprocket (driving chain wheel)
Outside diameter250 mm
Bore42 mm
Teeth8
Tooth width36 mm
Overall height60 mm
Weight6.1 kg
FitsFM WORLD 4LZ-6.0P (Ruilong) Combine Harvester
AvailabilityIn stock, ready to ship

What this part does

Of everything in the undercarriage this is the one part that is driven. Torque from the final drive arrives at the 42 mm bore and leaves through the 8 teeth, which push the track lugs along. Because it is the only power input, its tooth shape decides whether the belt is driven squarely or dragged: a tooth worn into a hook still rotates, but it lifts the belt up its flank instead of pushing it, and that is what appears as a jump or a derail under load.

The 8-tooth wheel against the 56-link track

This wheel and the track W3.5H-03A-30 are a matched pair on the 6.0P. Eight teeth at 250 mm outside diameter have to index the 90 mm pitch of the belt, so a wheel from another model with a different tooth count will not drive this loop however closely the bore matches.

Fitting notes

Draw the wheel off the final drive shaft and clean the shaft and keyway before the new wheel goes on, checking that the shaft itself is not scored or fretted. Fit the wheel, seat it fully and torque the retaining fastener to the figure listed in the service manual. After fitting, turn the track by hand and confirm the teeth pick up the lugs cleanly on both sides of the belt before the machine is put under load.

Before you fit it

Look at the final drive shaft seal and the shaft surface while the wheel is off. A leaking seal or a scored shaft will take out the new wheel’s bore.

Signs it needs replacing

  • Teeth worn into points or hooks, so the belt climbs instead of being driven
  • Tooth face width narrowed by rubbing against the belt lugs
  • A fretted or worn bore that lets the wheel run off centre on the shaft
  • The track jumping or derailing at the driven end under load

Compatibility and cross reference

Models covered

Listed for the FM WORLD 4LZ-6.0P Ruilong. The 8-tooth profile belongs to this model; check the tooth count and bore before ordering for another machine.

Confirming the right part

Match WD.4MC.2-01C and count 8 teeth. Confirm 250 mm outside diameter and a 42 mm bore on the old part.

Reading the old part

The wheel number is stamped on the hub face. Count the teeth as well, because a wheel of the same bore but a different tooth count will not index this track.

Questions we are asked about this part

How can I tell the teeth are too worn to reuse?

Compare the tooth profile with the unworn end of the wheel and check the 36 mm face width. Once the tip has hooked over, the tooth no longer pushes the lug squarely and the belt will jump.

Related parts