,

Guide Rail Weld, Rear (WD.4FE.33)

rear guide rail weld for the track run. In-stock replacement for the FM WORLD harvester. Order by part number; contact us for exact fitment.

Guide Rail Weld, Rear WD.4FE.33 — 640 x 45 x 55 mm

The rear guide rail for the FM WORLD 4LZ-6.0P track frame, 640 mm long and 45 mm in section, 55 mm high with the same 30 mm rail face, 4.4 kg. It is 45 mm longer than the front rail and covers the rear section of the frame.

Specifications

Part numberWD.4FE.33
TypeRear guide rail weld
Length x section x height640 x 45 x 55 mm
Rail face height30 mm
Weight4.4 kg
FitsFM WORLD 4LZ-6.0P (Ruilong) Combine Harvester
AvailabilityIn stock, ready to ship

What this part does

The rear rail is the longer slide of the pair. Its job is the same as the front one: the belt runs along the 30 mm face and the rail holds the run straight. The difference is where it sits and how much frame it covers, which is why a rail ordered by weight alone is easy to get wrong, since this longer rear rail is actually 0.3 kg lighter than the shorter front rail.

Rear 640 mm against front 595 mm — same face, different length

Both rails use a 30 mm face and stand 55 mm high, but this rear rail is 640 mm in a 45 mm section and 4.4 kg while the front rail W2.5D-03-32-00 is 595 mm in a 35 mm section at 4.7 kg. The longer rail being lighter is a reminder that weight is not a reliable way to tell them apart; length and section are.

Fitting notes

Check both frame faces are clean and that the rail beds down without rocking, then tighten it progressively from the middle outwards so it stays straight. The belt rubs the 30 mm face directly, so any high spot will wear a groove and start steering the run. With the rail on, turn the track through a full revolution and watch the belt stay on the face.

Before you fit it

Look for raised weld or burrs on the frame face before the rail goes down. A rail that rocks will wear on one end only.

Signs it needs replacing

  • A groove worn into the rail face where the belt has been running
  • The rear end worn or broken, letting the belt catch at the exit
  • A rail that has moved or been pulled down after a previous repair
  • Belt edge wear that points to the rail steering the run off line

Compatibility and cross reference

Models covered

Fitted to the FM WORLD 4LZ-6.0P Ruilong at the rear position. The front position uses W2.5D-03-32-00.

Confirming the right part

Measure 640 mm overall with a 45 mm section and match WD.4FE.33. A 595 mm rail with a 35 mm section is the front part.

Reading the old part

Read the rail from end to end for 640 mm and check the section at 45 mm. The number stamped on the body can be lost after a repaint.

Questions we are asked about this part

Can the front and rear rails be swapped if one is out of stock?

No. The rear rail is 640 mm and 45 mm section, the front is 595 mm and 35 mm section. Each covers its own part of the frame, so they are position-specific.

Related parts