Hold Roller Weld WD.4ME.28.1 — 145 mm, Tension Frame
A hold roller that belongs to the track tension frame of the FM WORLD 4LZ-4.0E, not to the main lower run. It is 145 mm outside diameter with a 62 mm bore and an 80 mm height, weighing 2.1 kg, and it is listed under the tension frame group of the crawler track system.
Specifications
| Part number | WD.4ME.28.1 |
|---|---|
| Type | Hold roller, track tension frame |
| Outside diameter | 145 mm |
| Bore | 62 mm |
| Height | 80 mm |
| Weight | 2.1 kg |
| Fits | FM WORLD 4LZ-4.0E Combine Harvester |
| Availability | In stock, ready to ship |
What this part does
This roller runs inside the tension frame rather than along the track frame. The frame slides when the belt is tightened, and the roller holds the belt against it through that movement, so it turns while also taking side load. A hold roller that has seized does not simply wear flat; it fights the tensioner, and the belt will not settle at the same setting twice.
A roller in the tension frame against a roller under load
The 145 mm hold roller and the 140 mm balance roller are within 5 mm of each other in diameter, which is why they get confused. This one has a 62 mm bore, weighs 2.1 kg and sits in the tension frame group; the balance roller is 2 kg with a 40 mm running width in the 03C group. Confirm the group from the parts diagram rather than from the diameter.
Fitting notes
Fit the roller into the tension frame with its pin and check the frame still slides freely through its full travel. The roller has to turn as the frame moves, so any pinch from a bent pin or a distorted frame will show up as a stiff spot rather than as play. Set track tension to the service manual figure after the frame is back in place.
Before you fit it
Check the pin, the frame bore and the frame itself for distortion before fitting, since a bent frame will keep a new roller loaded to one side.
Signs it needs replacing
- A seized roller that stops the tension frame sliding freely
- Side faces rubbed away by running against the frame
- Bore wear so the roller sits off line on its pin
- Track tension that will not hold the same setting after adjustment
Compatibility and cross reference
Models covered
Used on the FM WORLD 4LZ-4.0E track tension frame. The 6.0P tension frame uses different parts, so confirm the machine.
Confirming the right part
Match WD.4ME.28.1 with 145 mm outside diameter, 62 mm bore and 80 mm height. Do not order by diameter alone.
Reading the old part
This number sits on the roller end, and the group it belongs to is marked in the parts diagram. Read the bore rather than the outside diameter to tell it from the balance roller.
Questions we are asked about this part
Is this roller the same as the small roller under the track frame?
No. This one is 145 mm with a 62 mm bore and sits in the tension frame group; the roller under the track frame at 140 mm is the balance roller W2.5DX-03C-07-01-00.




