,

Balance Roller Weld (W2.5DX-03C-07-01-00)

welded balance (equalising) roller, 03C group. In-stock replacement for the FM WORLD harvester. Order by part number; contact us for exact fitment.

Balance Roller Weld W2.5DX-03C-07-01-00 — 140 mm

A balance roller for the FM WORLD 4LZ-4.0E track frame, 140 mm outside diameter and 85 mm overall height with a 40 mm running width, weighing 2 kg. It is the small roller of the 03C chassis group, listed alongside the larger support roller, the covers and the spacers that hold the group together.

Specifications

Part numberW2.5DX-03C-07-01-00
TypeWelded balance (equalising) roller
Outside diameter140 mm
Overall height85 mm
Running width40 mm
Weight2 kg
FitsFM WORLD 4LZ-4.0E Combine Harvester
AvailabilityIn stock, ready to ship

What this part does

This roller works between the main support positions. Because it is smaller than the loaded rollers, it does not carry the harvest weight; it keeps the lower run of the belt in contact and evens the load across the group. When it collapses, the belt has a gap to bridge rather than a roller to roll over, so the whole run starts to hammer instead of tracking smoothly.

The 140 mm balance roller against the 185 mm support roller

On the 4.0E this roller is the 140 mm, 2 kg item with a 40 mm running width. The 185 mm, 2.7 kg roller W2.5DX-03C-06-01-00 belongs to the 6.0P and sits at the loaded support position. They differ in diameter, height and machine, so neither fits the other’s place even though the part numbers share the 03C prefix.

Fitting notes

Confirm the roller turns freely on its shaft before it goes in, then fit the spacers and cover for this position so it runs square to the belt line. The running face carries no load, so a roller that feels tight after fitting is being pinched by a worn spacer rather than by the belt; check the spacers instead of tightening the mounting further.

Before you fit it

Check the spacers, cover and shaft at this position. A worn spacer will pinch a new roller and wear its face again within a short time.

Signs it needs replacing

  • A flat or stepped running face after the roller stopped rotating
  • Bore and shaft wear that lets the roller run at an angle
  • A collapsed roller leaving the belt bridging a gap in the run
  • Hammering or uneven belt movement between the support positions

Compatibility and cross reference

Models covered

Listed for the FM WORLD 4LZ-4.0E. The 6.0P uses a different 03C roller, so confirm the machine before ordering.

Confirming the right part

Read 140 mm outside diameter and 40 mm running width, and match W2.5DX-03C-07-01-00. A 185 mm face belongs to the 6.0P support roller.

Reading the old part

The weld number is on the roller body, not on the cover. Measure across the running face rather than the flange, since the flange reads wider than 140 mm.

Questions we are asked about this part

Is this roller loaded like a support roller?

No. At 140 mm and 2 kg it is the smaller balance roller of the group; the loaded positions use the larger support roller, and both are needed for the belt to run flat.

Related parts