Tension Wheel WD.4MC.27-01 — 280 mm, 8.7 kg
The large tension wheel for the FM WORLD 4LZ-4.0E track frame: 280 mm outside diameter, 70 mm bore, 120 mm overall height with a 50 mm running width, 8.7 kg. It is the biggest roller on this undercarriage and it sits at the tension end of the track loop.
Specifications
| Part number | WD.4MC.27-01 |
|---|---|
| Type | Track tension wheel (front idler) |
| Outside diameter | 280 mm |
| Bore | 70 mm |
| Overall height | 120 mm |
| Running width | 50 mm |
| Weight | 8.7 kg |
| Fits | FM WORLD 4LZ-4.0E Combine Harvester |
| Availability | In stock, ready to ship |
What this part does
This wheel closes the track loop at the tension end and holds the belt tight through the tensioner. Its 280 mm diameter is what sets how much belt is wrapped at that end of the frame, and it is not driven, so it turns only because the belt pulls it round. A wheel that has stopped turning, or one whose bore is worn enough to let it wobble, shows up as a slack belt that slaps and as uneven wear across the belt width.
The 280 mm tension wheel against the 185 mm support roller
Both turn under the belt, but only one of them sets tension. This wheel is 280 mm diameter, 50 mm running width and 8.7 kg on the 4.0E, where the belt wraps it at the tension end. The 185 mm support roller at 2.7 kg is the 6.0P part that carries weight under the lower run. Size and machine both separate them.
Fitting notes
Check the wheel turns freely on its shaft and that the bore is not worn oval before it goes onto the tension frame. Take up tension with the tensioner, run the track through a few revolutions to let the belt settle, then reset tension to the figure in the service manual. A wheel fitted to a worn shaft will keep working loose, so inspect the shaft in the same job.
Before you fit it
Inspect the shaft and the tension frame bore before fitting. A worn shaft will take out the new wheel’s 70 mm bore quickly.
Signs it needs replacing
- A wheel that will no longer turn freely and wears flat on one side
- Bore wear letting the wheel run off line and the belt wander
- A worn running face causing the belt to run slack and slap
- Side faces rubbed by the tension frame as the wheel moves
Compatibility and cross reference
Models covered
For the FM WORLD 4LZ-4.0E track frame. The 6.0P runs a different tension arrangement, so confirm the machine.
Confirming the right part
Match WD.4MC.27-01 with 280 mm outside diameter and 50 mm running width. No other roller in this range is that large.
Reading the old part
The number is stamped on the hub end. The diameter alone separates it, since no other roller on this machine measures 280 mm.
Questions we are asked about this part
Should I change the tension wheel when I change the track?
Inspect the running face and the bore first. A worn or seized wheel will wear a new belt unevenly, so if it is worn flat or will not turn freely, renew it with the belt.





