,

Tension Arm Weld (W3.5H-03B-17-01-00)

tension arm weld carrying the tension wheel. In-stock replacement for the FM WORLD harvester. Order by part number; contact us for exact fitment.

Tension Arm Weld W3.5H-03B-17-01-00 — 210 x 53 x 130 mm

The tension arm for the FM WORLD 4LZ-6.0P track frame: 210 x 53 x 130 mm, 0.95 kg, with a 20 mm upper bore and 55 mm and 45 mm lower bores. It is the link that carries the tension wheel and lets it move as the belt is tightened.

Specifications

Part numberW3.5H-03B-17-01-00
TypeTension arm weld
Overall dimensions210 x 53 x 130 mm
Upper bore20 mm
Lower bores55 mm / 45 mm
Weight0.95 kg
FitsFM WORLD 4LZ-6.0P (Ruilong) Combine Harvester
AvailabilityIn stock, ready to ship

What this part does

The arm is the moving link between the frame and the tension wheel. Its bores take the pivot pin and the shaft the wheel runs on, so it has to swing without slack while holding the wheel square to the belt. Wear in those bores does not appear as a flat spot on the roller; it shows as the wheel sitting at an angle, which then wears one edge of the belt.

A pivot arm against the wheel it carries

This arm is 0.95 kg of welded steel with three bores. The wheel it carries on the 6.0P is a separate part, and the two wear differently: the roller wears on its running face while the arm wears in its bores and at the weld where the bend is formed. That is why a slack track is sometimes an arm problem rather than a roller problem.

Fitting notes

Check the bores for ovality and the pins for step wear before the arm goes back, then fit it so it swings freely through its full travel with no tight spot. A dry or distorted pivot will bind and hold the wheel off line. Take up tension only after the arm moves cleanly, and use the adjustment and torque figures from the service manual.

Before you fit it

Measure the pivot bores and the pins before refitting. An oval bore will not be cured by tightening the pin.

Signs it needs replacing

  • Bores worn oval so the arm sits loose on its pivot
  • Cracks at the weld where the arm is bent
  • The arm bent so the tension wheel no longer squares to the belt
  • A tight pivot that stops the wheel following a tension adjustment

Compatibility and cross reference

Models covered

Fitted to the FM WORLD 4LZ-6.0P Ruilong track frame. The arm and the wheel it carries are separate parts, so check both on the same machine.

Confirming the right part

Match W3.5H-03B-17-01-00 at 210 x 53 x 130 mm with a 20 mm upper bore and 55 / 45 mm lower bores.

Reading the old part

The three bores are the identifiers: 20 mm at the top, 55 mm and 45 mm at the bottom. Read them with a bore gauge rather than by eye.

Questions we are asked about this part

What causes the tension wheel to sit at an angle?

Usually the arm rather than the wheel. Oval bores or a bent arm tilt the wheel so it loads one edge of the belt, and that wear shows on the belt before it shows on the roller.

Related parts