,

Support Roller Weld (W2.5DX-03C-06-01-00)

welded track support roller. In-stock replacement for the FM WORLD harvester. Order by part number; contact us for exact fitment.

Support Roller Weld W2.5DX-03C-06-01-00 — 185 mm

A welded support roller for the lower run of the FM WORLD 4LZ-6.0P track frame. The running face is 185 mm outside diameter, the bore is 65 mm and the roller stands 80 mm tall; it weighs 2.7 kg and turns on a shaft carried in the chassis roller group.

Specifications

Part numberW2.5DX-03C-06-01-00
TypeWelded track support roller
Outside diameter185 mm
Bore65 mm
Height80 mm
Weight2.7 kg
FitsFM WORLD 4LZ-6.0P (Ruilong) Combine Harvester
AvailabilityIn stock, ready to ship

What this part does

Support rollers are what the machine’s weight actually rests on. Several sit under the track frame, and each carries a share of the load as the belt passes over it. Because that load is spread across the group, one roller that has stopped turning shows up first as a flat worn on its own face and a belt that will not sit evenly, not as a sudden failure.

The 185 mm support roller against the 140 mm balance roller

Both are chassis rollers but they are not the same part. This support roller is 185 mm diameter, 80 mm tall and 2.7 kg, and belongs to the 6.0P. The balance roller W2.5DX-03C-07-01-00 is 140 mm diameter and 2 kg and belongs to the 4.0E, where it serves a different position in the same roller group. Ordering one to fit the other’s place will not work.

Fitting notes

Check the shaft and the bore in the frame before fitting, and confirm the new roller turns freely on its shaft by hand. Fit the covers and spacers that go with this position so the roller is held square and dirt is kept out of the bore. Lubrication points and the running clearance to the belt are given in the service manual; do not set them by eye.

Before you fit it

Inspect the shaft, the covers and the spacers at this position before refitting. A worn spacer lets the roller move sideways and rub the belt edge.

Signs it needs replacing

  • A flat worn on the running face where the roller has stopped turning
  • A seized or stiff roller that drags the belt instead of rolling under it
  • Bore wear that lets the roller sit loose or at an angle on its shaft
  • The belt slapping or riding unevenly over one roller position

Compatibility and cross reference

Models covered

Fitted to the FM WORLD 4LZ-6.0P Ruilong lower track run. Confirm the 185 mm face and the 65 mm bore against the old roller.

Confirming the right part

Match W2.5DX-03C-06-01-00 with 185 mm outside diameter, 65 mm bore and 80 mm height. The 4.0E roller of a similar name is 140 mm and a different part.

Reading the old part

The number is stamped on the roller end face next to the shaft. Measure the face at 185 mm across and the bore at 65 mm while the old roller is off.

Questions we are asked about this part

Why does one roller wear flat while the others are still round?

A flat face is the sign the roller stopped rotating, usually from a dry or seized bore. Greasing alone will not restore it; the roller and its shaft need to be checked together.

Related parts