,

Half Shaft Left Arm ZKB65a-W3.5H-205-500BG

Left-hand half shaft with steering arm. Part ZKB65a-W3.5H-205-500BG. In-stock replacement for the FM WORLD 4LZ-6.0P (ZKB85) gearbox.

Half Shaft Left Arm (ZKB65a-W3.5H-205-500BG) FM WORLD 6.0P

The left-hand half shaft is 60 mm at the shaft, 157 mm across the arm and 448 mm long, weighing 7.1 kg. It is the shorter half of the pair: the right-hand arm measures 470 mm, so a left arm and a right arm are never interchangeable even though they look alike.

Specifications

Part NumberZKB65a-W3.5H-205-500BG
Part TypeHalf shaft with steering arm, left
Shaft Diameter60 mm
Arm Width157 mm
Length448 mm
Weight7.1 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

What this part does

The left side of this final drive sees load in the opposite direction to the right, and its shaft is 22 mm shorter to suit the narrower side of the housing. That shorter length is not a manufacturing tolerance; it positions the arm eye so the steering linkage works through the angle it was designed for. Because the inner spline takes drive and the outer arm takes steering thrust, the left shaft usually shows spline movement before it shows anything at the arm.

What the 448 mm figure protects

At 448 mm the arm eye lands where the release lever expects it. A 470 mm shaft put in its place moves the eye outward, which changes the release angle on that side only; the machine then steers late on the left while the right feels normal. Operators usually read that as a clutch fault and rebuild the pack twice before measuring the shaft. Keep the old part tagged by side and measure it end to end.

Fitting notes

Lift the shaft by its body and never by the arm eye, and keep the two sides separated on the bench. Check the spline for step wear, the arm eye for ovality and the seal journal for a groove, then confirm the arm swings through its travel without fouling. Preload and steering adjustment afterwards follow the service manual for this gearbox.

Before you fit it

Compare the new shaft against the old one end to end before fitting. Twenty-two millimetres is enough to see, and it is the only reliable check once the number is illegible.

Signs it needs replacing

  • Uneven steering, worse on one side
  • Spline polish or step at the drive end
  • Oval eye or hairline crack at the arm end
  • Oil film at the seal journal after a season

Compatibility and cross reference

Models covered

Left-hand half shaft of the final drive and steering linkage on the FM WORLD 4LZ-6.0P. It is 22 mm shorter than the right-hand shaft, which is the figure that keeps the two apart on the shelf.

Confirming the right part

Confirm ZKB65a-W3.5H-205-500BG on 448 mm length, 60 mm shaft and 157 mm arm. A 470 mm arm is the right-hand part and carries a different number.

Reading the old part

The stamping is on the arm body and often lost under paint. Measure 448 mm end to end; a left arm that reads 470 mm is the right-hand part.

Questions we are asked about this part

Will the right-hand arm fit on the left side?

It will bolt up, which is the problem. At 470 mm against 448 mm it puts the arm eye out of position, and the resulting steering fault looks like a clutch problem.

What should I measure on a used half shaft?

Three things: overall length 448 mm, shaft diameter 60 mm and the arm eye for ovality. The spline condition decides whether the shaft can stay in service at all.

Related parts