Starter Assembly 4G33-300000C for FM WORLD 6.0P
This is the 4G33-300000C starter for the FM WORLD 4LZ-6.0P, a 7.15 kg cranking motor at 270 × 200 × 100 mm. It is the -C build of the engine starter and is kept as a separate part number from the -F version.
Specifications
| Part number | 4G33-300000C |
|---|---|
| Type | Electric starter assembly |
| Size | 270 × 200 × 100 mm |
| Weight | 7.15 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
| Availability | in stock, ready to ship |
What this part does
The motor converts battery current into rotation through its armature and field, while the solenoid performs two jobs in sequence: it levers the drive pinion into the flywheel ring gear, then makes the heavy contacts that energise the motor. A one-way clutch between pinion and armature releases as soon as the engine catches, preventing the faster engine from driving the starter. Because cranking draws a very high current for a short period, clean contacts and a sound battery are as important as the motor itself.
No-crank against a wiring fault
An open control wire or a bad ground can stop the starter just as a dead motor does. Trace the signal at the solenoid and the voltage at the main terminal before replacing the unit, so a wiring fault is not mistaken for a starter fault.
Fitting notes
Seat the starter flush on its engine mounting and confirm the pinion engages the ring gear without binding, then attach the main feed and solenoid wire with clean terminals. Follow the service manual for mounting and cable torque.
Before you fit it
With the old unit removed, turn the flywheel and look for damaged ring-gear teeth around its full circle, and check the pinion clutch for slip. Partial or one-sided wear explains a starter that works only sometimes.
Signs this part needs replacing
- Complete silence when the key is held, with the solenoid not energising
- Audible solenoid click but the armature does not spin
- Cranking that drags or stalls despite a good battery
- A high-pitched grind as the pinion meets worn ring teeth
- The motor spins but the engine does not, from a slipping clutch
- Starting that works cold and cuts out once the unit is hot
Compatibility and cross-reference
Where it fits
Engine mounting on the FM WORLD 4LZ-6.0P, driving the flywheel ring gear through the pinion.
Confirming the correct part
Confirm by part number 4G33-300000C and the connector and mounting arrangement.
Reading the old part
Recognise it by the solenoid and drive pinion, and match the electrical terminals and bolt pattern to the old unit.
Frequently asked questions
What is the difference between the -C and -F starters?
They are separate part numbers for the same engine family. Select by the exact part number and the electrical and mounting fit, rather than assuming they interchange.
Should the pinion stay engaged after start-up?
No. It retracts and the one-way clutch releases, so the engine cannot drive the starter once it is running.





