Water Pump 4G33TC-082000A for FM WORLD 6.0P
This is the engine water pump for the FM WORLD 4LZ-6.0P, a centrifugal pump 240 × 185 × 150 mm, weight 3.5 kg. It circulates coolant between the engine and the radiator to keep the engine at working temperature.
Specifications
| Part number | 4G33TC-082000A |
|---|---|
| Type | Engine water pump (centrifugal) |
| Size | 240 × 185 × 150 mm |
| Weight | 3.5 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
| Availability | in stock, ready to ship |
What this part does
A finned impeller on the shaft spins and pushes coolant through the block, head, and radiator. The shaft runs in a sealed bearing and a mechanical seal keeps coolant from leaking along it, while a small weep hole below the seal lets any coolant that gets past drip out instead of reaching the bearing. The pump is driven by the engine and its flow is what carries heat to the radiator; without it the engine overheats even with a full coolant level.
Weep hole leak against a loose hose
A loose hose leaks at the connection. A drip from the pump’s own weep hole means the internal shaft seal is failing, which is a pump fault rather than a hose or clamp problem.
Fitting notes
Fit the pump with a new gasket on a clean, flat face and tighten to the service manual sequence, then set the belt tension and refill and bleed the coolant. Turn the pulley by hand to confirm it is free before starting.
Before you fit it
Inspect the impeller and the mounting face while the old pump is off, and check the weep hole and bearing for noise or play. Coolant that has passed the seal will wash out the bearing grease, so a weeping pump should not be left in service.
Signs this part needs replacing
- Coolant dripping from the weep hole as the shaft seal fails
- Growling or whining and shaft play from the bearing
- Overheating with normal coolant level and a working fan
- Corroded or broken impeller reducing coolant flow
Compatibility and cross-reference
Where it fits
Front of the engine in the FM WORLD 4LZ-6.0P, in the coolant circuit to the radiator.
Confirming the correct part
Confirm by part number 4G33TC-082000A and the mounting face and pulley fit.
Reading the old part
Identify the pump by the impeller housing and weep hole, and match the bolt pattern and pulley rather than relying on the tag.
Frequently asked questions
What is the weep hole for?
It lets coolant past a failing shaft seal drip out rather than reach the bearing, giving an early warning of seal failure.
Why does a bad pump cause overheating with coolant still full?
The pump moves the coolant, so a worn bearing or damaged impeller stops circulation even though the system is full.





