Cutter Bar Friction Plate W2.0-01-01-03G-08 — 105 x 35 x 2 mm
This is the longer of the two friction plates under the knife on the FM WORLD 4LZ-4.0E cutter bar, measuring 105 mm across. It carries the knife back over the wider support positions where a short plate would leave the moving sections unsupported at the end of their stroke. Like the 70 mm plate it is a hardened, replaceable wear surface rather than part of the frame.
Specifications
| Part number | W2.0-01-01-03G-08 |
|---|---|
| Type | Cutter bar friction (wear) plate |
| Length x width x thickness | 105 x 35 x 2 mm |
| Weight | 0.09 kg |
| Fits | FM WORLD 4LZ-4.0E Combine Harvester |
| Availability | In stock, ready to ship |
What this part does
Its job is identical in principle to the shorter plate but spans a longer section of the knife travel. The extra length keeps the rear of the knife section supported through the full stroke, stopping it from dropping and digging into the frame at full extension.
Why the bar needs both a 105 mm and a 70 mm plate
The two plates cover different positions on the same bar: this 105 mm, 0.09 kg plate supports the longer travel zones, and the 70 mm, 0.06 kg plate fits the shorter positions. Mixing them leaves either a gap under the knife or a plate that cannot bolt down. The positions are not interchangeable even though both are 2 mm thick.
Fitting notes
Mount it on a fully cleaned, flat face so no chaff can tilt it. Follow the lubrication schedule in your service manual for the knife and wear surfaces; where the manual calls for a dry sliding face, keep it clean and oil-free, because grease on a dusty header collects grit into an abrasive layer.
Before you fit it
Check the frame recess under the old plate is still flat and not worn through. A damaged frame has to be restored before a new plate can hold the knife at the correct height.
Signs it needs replacing
- A polished hollow or ridge worn along the knife path
- The knife dropping at full stroke and clipping the frame
- Bolt holes elongated or the plate cracked across its width
- Ragged cutting that does not improve after the knife is re-registered
Compatibility and cross reference
Models covered
Fits the FM WORLD 4LZ-4.0E cutter bar at the 105 mm support positions; verify the length and number before ordering.
Confirming the right part
Measure the old plate at 105 mm and confirm the number W2.0-01-01-03G-08. A 70 mm part is the 03G-06 and will not fit this position.
Reading the old part
This is the long plate of the pair: 105 mm against the 70 mm …-06 plate. Both are 35 mm wide and 2 mm thick, so on the bench only length separates them; check the number as well rather than trusting the length alone, since a worn long plate can measure close to a new short one.
Questions we are asked about this part
Can I fit two short plates instead of one long one?
No. The position is designed for a single 105 mm plate with its own bolt locations; butting shorter plates leaves a seam under the knife back and does not give the same support.





