Cutter Bar Assembly W2.5E-01D-01-03-03-00A — 2.2 m, 29 Sections
This is the complete cutter bar for the 2.2 m header on the FM WORLD 4LZ-6.0P Ruilong. The 2350 mm frame carries 29 knife sections that move as one sickle against the ledger plates, restoring the full cutting geometry in one part. At 5.9 kg it is built for the narrower header, distinct from the 2.36 m bar.
Specifications
| Part number | W2.5E-01D-01-03-03-00A |
|---|---|
| Type | Complete cutter bar assembly with fixed knife |
| Overall dimensions | 2350 x 115 x 50 mm |
| Knife sections | 29 |
| Weight | 5.9 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) Combine Harvester |
| Availability | In stock, ready to ship |
What this part does
This unit gives the 2.2 m header one aligned frame. Each of the 29 sections has to finish its stroke centred over a guard, or the drive loads unevenly and stalks tear instead of shearing. A bent frame cannot be corrected by fitting fresh blades, so the complete assembly re-establishes the reference all the smaller parts depend on.
The 2.2 m 29-section bar against the 2.36 m 31-section bar
Choose the 2311 bar for the 2.2 m header: it carries 29 sections on a 2350 mm frame. The 2345 bar is 150 mm longer and holds two extra sections for the 2.36 m header. The header width fixes the part, and neither the section count nor the mounting holes match across the two.
Fitting notes
Offer the assembly up to a clean header face and bolt it square before the knife head is attached. Then work the sickle through its travel by hand, checking every section centres on its guard and nothing binds. Register the guards and hold-downs to the new frame rather than trusting the old settings, using the points and lubrication in the service manual.
Before you fit it
Look over the header face for broken or recessed seats, since the new frame needs a flat surface to bed down.
Signs it needs replacing
- A frame out of true so the sections no longer centre
- The sickle binding or cutting unevenly across the 2.2 m span
- Wear spread across several guard and guide seats in the frame
- A previous repair that has lost the original geometry
Compatibility and cross reference
Models covered
Built for the FM WORLD 4LZ-6.0P Ruilong on the 2.2 m header; verify the header width before ordering.
Confirming the right part
Count 29 sections and read the number W2.5E-01D-01-03-03-00A; a 31-section bar is the wider 2345 assembly.
Reading the old part
2350 x 115 x 50 mm with 29 knife sections and 5.9 kg. Counting sections is quicker than measuring, but do both: the 31-section bar of the same family is 2500 mm, and a bar with the wrong count will not time correctly against the drive.
Questions we are asked about this part
How do I confirm this is the 2.2 m bar?
Count 29 sections and match the part number W2.5E-01D-01-03-03-00A. The wider 2.36 m bar has 31 sections and a different number.




