Vertical Grain Lifting Auger W3.5H-02-10-01-03-00 — 1675 mm
This is the vertical auger that lifts clean grain upward from the cleaning system toward the grain tank on the FM WORLD 4LZ-6.0P Ruilong. It stands 1675 mm tall with a 125 mm flight and a 35 mm shaft, turning inside a vertical housing so the helical flight pushes grain straight up rather than across. Keeping this lift working is what moves threshed grain out of the cleaning shoe continuously during harvest.
Specifications
| Part number | W3.5H-02-10-01-03-00 |
|---|---|
| Type | Vertical grain lifting auger |
| Overall length | 1675 mm |
| Flight width | 125 mm |
| Shaft diameter | 35 mm |
| Weight | 5.6 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) Combine Harvester |
| Availability | In stock, ready to ship |
What this auger does
On a vertical lift the grain’s own weight works against the conveyor, so the flight face has to keep positive contact with the column of grain. As the flight edge wears and the housing clearance opens, grain slips back down and the lift loses capacity, showing as grain holding in the bottom of the elevator rather than reaching the tank. The vertical orientation also means the top and bottom bearings carry the full rotating weight.
The vertical lifting auger against the horizontal grain auger
This 1675 mm auger moves grain upward against gravity inside a vertical housing, while the 2374 horizontal grain auger carries it sideways at 1215 mm. The two have different mount orientations and shaft sizes, so they are not interchangeable even though both convey clean grain.
Fitting notes
Guide the weldment down a clean vertical housing and line up the upper and lower bearings, leaving them free while the shaft is checked. Work it through manual rotations and watch the helix travel the entire height, confirming it never brushes the housing. Before the drive is finally coupled, double-check the turning sense against the helix hand, because a vertical conveyor running backwards has no lift at all. Only the bearings receive lubrication per the manual; the helix is left bare.
Before you fit it
Check the vertical housing for thinning or pin-holing along its lower curve, since a worn housing defeats a new auger.
Signs it needs replacing
- Grain slipping back down and pooling at the elevator base
- Worn flight edges with enlarged clearance to the housing
- A bent or out-of-true shaft making the flight rub
- Top or bottom bearing wear showing as vertical runout or noise
Compatibility and cross reference
Models covered
Listed for the FM WORLD 4LZ-6.0P Ruilong vertical elevator; confirm the 1675 mm length and 35 mm shaft.
Confirming the right part
Match W3.5H-02-10-01-03-00 and 1675 mm. Confirm vertical orientation and correct rotation on fit.
Reading the old part
1675 mm long, 125 mm flight width, 35 mm shaft, 5.6 kg. A vertical lifting auger wears on the lower flights first because that is where the grain load sits, so read the wear pattern down the length instead of judging from the top flight.
Questions we are asked about this auger
Grain is not reaching the tank but the auger is turning. Why?
Worn flight edges or a reversed rotation let the grain fall back instead of lifting. Check the edge clearance and confirm the drive turns in the correct direction for the flight hand.





