,

Bevel Gear 20 Teeth

20-tooth bevel gear with keyed bore. Part W2.5-02-03-02-02. In-stock replacement for the FM WORLD 4LZ-6.0P header and unloading drive.

Bevel Gear 20 Teeth for the FM WORLD 6.0P Threshing Drive

This is the 20-tooth bevel gear in the threshing drive, 64 mm outside, 20 mm bore and 50 mm across the hub, weighing 0.3 kg. Its longer hub and plain bore distinguish it from the 19-tooth splined gear it runs against.

Specifications

Part NumberW2.5-02-03-02-02
Part TypeBevel gear
Outside Diameter64 mm
Bore20 mm
Hub Height50 mm
Teeth20
Weight0.3 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

What this part does

The tooth faces wear in the same way as the larger gear: pitting, scoring and a slowly opening backlash, with noise as the first audible sign. Because this gear mounts on a plain 20 mm bore with a key, the key and keyway are the parts to check alongside the teeth. A keyway that has opened lets the gear index on the shaft, and the repeated shock is harder on the teeth than the steady load. The 50 mm hub also has to run true; a bent shaft or a worn hub shows as a pattern that is heavier on one side of the teeth.

The 20-tooth gear and the 19-tooth splined gear

This gear is smaller, with a 20 mm keyed bore and a long hub; the driven gear is 92 mm with a 32 mm spline. The two are a matched mesh, and neither the bore nor the tooth count can be swapped. Confirming both parts together is the safe way to order.

Fitting notes

Check the key, keyway and shaft before fitting, then verify the contact pattern and the backlash against the service manual. The gear is seated fully on its shaft and the housing filled with the specified oil. A worn mating gear should be replaced in the same job.

Before you fit it

The long hub makes shaft condition important. Measure the journals and check the keyway before the gear goes on, since a loose hub feeds a shock into the mesh.

Signs it needs replacing

  • Pitting or scoring on the conical faces
  • Growing whine from opening backlash
  • A keyway that has opened or a loose key
  • Contact pattern heavy on one side of the teeth

Compatibility and cross reference

Models covered

The 20-tooth bevel gear in the threshing drive of the FM WORLD 4LZ-6.0P, meshing with the 19-tooth driven gear.

Confirming the right part

Confirm W2.5-02-03-02-02 on 20 teeth, 64 mm outside and the 20 mm keyed bore. The splined gear is a different part.

Reading the old part

Count the teeth and measure the plain bore. Twenty teeth and the 20 mm keyway separate this gear from the splined one.

Questions we are asked about this part

Can this gear be replaced on its own?

Only if the mating 19-tooth gear is still clean and the contact pattern is even. Once either member is pitted or scored, the pair is replaced together, since they were lapped as a set.

What does a one-sided contact pattern mean?

Usually a shaft or alignment problem rather than a worn gear. The mounting and shaft should be checked before a new gear is fitted, or the new gear will wear the same pattern.

Related parts