Track W3.5H-03A-30 — 550 x 90 x 56, 203 kg
The crawler track listed for the FM WORLD 4LZ-6.0P Ruilong. The figure 550 x 90 x 56 is read as three separate measurements: 550 mm across the belt, a 90 mm pitch between link centres, and 56 links making up the one loop. It arrives as a sealed loop of 203 kg, the heaviest running item on this undercarriage.
Specifications
| Part number | W3.5H-03A-30 |
|---|---|
| Type | Complete crawler track (one loop) |
| Size | 550 x 90 x 56 mm (width x pitch x links) |
| Belt width | 550 mm |
| Pitch | 90 mm |
| Link count | 56 |
| Weight | 203 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) Combine Harvester |
| Availability | In stock, ready to ship |
What this part does
This belt is the only part of the machine that meets the ground, so it takes the harvest load and turns the drive coming through the chain wheel into forward movement. All three figures matter together: the 550 mm width sets the footprint, the 90 mm pitch has to mesh with the teeth that drive it, and the 56 links fix the length of the loop around the wheel and rails.
Why the width alone is not a size
A belt sold by width alone will fit nothing. If the pitch is wrong the links ride up the drive teeth instead of seating between them; if the link count is short the loop cannot close around the frame, and if it is long the tensioner runs out of travel before the belt is tight. Read all three numbers off the old belt, not just the 550 mm.
Fitting notes
Bring the machine onto level ground and slacken the tensioner before the old loop is split, so the new belt can be laid over the drive and tension wheels without being forced. Join the loop, then take up tension and let the belt settle by turning the track through a few revolutions. Set the final tension and check the rail contact with the figures given in the service manual rather than by feel.
Before you fit it
Inspect the drive wheel teeth, the tension wheel running face and both guide rails before fitting. A worn part left in place will cut the life of the new belt short.
Signs it needs replacing
- A torn or broken link, or a split running across the belt
- Drive lugs worn or torn so the chain wheel slips and the track jumps
- One edge worn thin from running against a bent or worn rail
- A belt that will no longer hold tension and slaps on the frame
Compatibility and cross reference
Models covered
Supplied for the FM WORLD 4LZ-6.0P Ruilong. Confirm 550 x 90 x 56 against the old belt before ordering, since other models in the range use different loops.
Confirming the right part
Read the three figures from the old belt sidewall: 550 width, 90 pitch, 56 links. Any deviation changes the part number W3.5H-03A-30.
Reading the old part
The three figures are moulded into the belt sidewall. Read them where the belt is cleanest, usually mid-run rather than at a worn end.
Questions we are asked about this part
Do the three numbers on a track mean width, pitch and length in metres?
No. On this size 550 is the belt width in millimetres, 90 is the pitch between links in millimetres, and 56 is the count of links in the loop, not a length.
Should the drive wheel be renewed with a new track?
Inspect the chain wheel teeth first. A worn tooth profile damages a new belt quickly, so if the teeth are hooked or the tooth width has dropped, replace the wheel in the same job.





