,

Unloading Auger B (W2.5B-04BX-04B-02-00)

unloading auger B. In-stock replacement for the FM WORLD harvester. Order by part number; contact us for exact fitment.

Unloading Auger B W2.5B-04BX-04B-02-00 — 1735 mm, 10.05 kg

This is the B section of the unloading auger that moves grain out of the grain tank during discharge on the FM WORLD 4LZ-6.0P Ruilong. It is 1735 mm long with a 165 mm flight and a 60 mm shaft, weighing 10.05 kg, and forms one of the long conveying sections of the unloading system. It works in train with the other unloading sections and has to be timed to them.

Specifications

Part numberW2.5B-04BX-04B-02-00
TypeUnloading auger B section
Length x flight diameter1735 mm x 165 mm
Shaft diameter60 mm
Weight10.05 kg
FitsFM WORLD 4LZ-6.0P (Ruilong) Combine Harvester
AvailabilityIn stock, ready to ship

What this auger does

The unloading auger moves a high volume of grain in a short time during discharge, so the flight face and outer edge wear heavily. A worn edge opens the tube clearance and slows the emptying rate, and on a multi-section system the flight timing matters as much as the edge condition. The 60 mm shaft and 165 mm flight identify this specific B section.

Unloading auger B against the A unloading section

This B section is 1735 mm with a 60 mm shaft, while the 1879 A section is a different length and mount for the 4.0E frame. Each unloading position takes its own section, and the two are not interchangeable; the flight timing must be set when either is fitted.

Fitting notes

Make sure the tube and bearing bores are clean before the B section goes in. The flight must be timed to the neighbouring section, and that alignment is done while the fasteners remain free. Several manual rotations of the whole unloader then reveal whether the joint travels at a steady gap without snagging. Once satisfied, lock the mounts and oil the bearings, and finish by confirming grain is driven toward the discharge end.

Before you fit it

Check the A section and the middle short auger, since the unloading train works as one timed unit.

Signs it needs replacing

  • Slower emptying as the flight edge wears and clearance opens
  • Grain catching at the joint from lost flight timing
  • A bent section or shaft rubbing the tube
  • Bearing or journal wear at the 60 mm shaft seats

Compatibility and cross reference

Models covered

Listed for the FM WORLD 4LZ-6.0P Ruilong unloading system; confirm the 1735 mm and 60 mm shaft.

Confirming the right part

Match W2.5B-04BX-04B-02-00 and the 60 mm shaft. Confirm B-position and flight timing on fit.

Reading the old part

1735 mm long with a 165 mm flight diameter and a 60 mm shaft, 10.05 kg. The 60 mm shaft is heavier than the 40 mm of the other unloading section, so a shaft that measures 40 mm is a different part no matter how similar the flight looks.

Questions we are asked about this auger

Do the two unloading auger sections need to be timed together?

Yes. On a multi-section unloading system the flights are timed so grain passes smoothly across the joint. Follow the service manual timing steps; fitting a section at the wrong angle causes grain to catch.

Related parts