,

Chain Wheel 10A x22 W2.5B-04HX-11-02

22-tooth chain wheel in the 10A series. Part W2.5B-04HX-11-02. In-stock replacement for the FM WORLD 4LZ-6.0P header and threshing system.

Chain Wheel 10Ax22 (W2.5B-04HX-11-02) for the FM WORLD 6.0P

This is a 22-tooth sprocket in the 10A series, 120 mm outside, 22 mm bore and 30 mm across the hub, weighing 0.65 kg. Its 10A series is the important distinction: it is not the same chain size as the 08B sprockets, and the two series never interchange.

Specifications

Part NumberW2.5B-04HX-11-02
Part TypeChain wheel, 22 teeth
Series10A
Outside Diameter120 mm
Bore22 mm
Hub Height30 mm
Teeth22
Weight0.65 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

What this part does

With 22 teeth the load is shared across more teeth than on the smaller sprockets, so this one usually shows wear later. When it does wear, the profile change is the same: hooking at the tips and a chain that leaves late. The more common mistake with this part is not wear but series: a 10A sprocket and an 08B chain are different sizes, and forcing them together damages both, even though the bores are close.

10A sprocket against the 08B sprockets

The 08B sprockets run a smaller chain; this one runs the 10A series and is 120 mm outside with 22 teeth. Bore sizes can look similar, which is why the series and the tooth count must be checked rather than the bore alone. A chain that does not sit in the tooth gap is the warning of a series mismatch.

Fitting notes

Confirm the chain series before fitting and check the keyway and the shaft, then seat the sprocket against its shoulder. Inspect the mating chain for elongation, since a 10A chain that has grown will hook even a new sprocket. Tension and alignment follow the service manual.

Before you fit it

Check the chain sits fully in each tooth gap before the guard goes on. A chain riding proud is a series mismatch, not a tension problem.

Signs it needs replacing

  • Hooking at the tips despite the larger tooth count
  • Chain leaving the teeth late or knocking
  • Worn keyway or a bore that rocks on the shaft
  • Chain that does not sit in the tooth gaps (series mismatch)

Compatibility and cross reference

Models covered

The 22-tooth 10A sprocket in the drive of the FM WORLD 4LZ-6.0P. It runs only the 10A chain, so series and tooth count are confirmed together.

Confirming the right part

Confirm W2.5B-04HX-11-02 on 22 teeth, 120 mm outside and the 10A series. The 08B sprockets run a different chain.

Reading the old part

Count the teeth and confirm the series. The 22-tooth count and the 10A chain size identify this sprocket even when the number is faint.

Questions we are asked about this part

Can an 08B chain run on this sprocket?

No. The 10A series is a different chain size and the links will not seat in the tooth gaps. The series marking and the tooth count are the checks, not the bore.

Does a larger sprocket wear more slowly?

Each tooth cycles fewer times per revolution, so in the same load it tends to wear later, but a worn chain will still hook it. The chain condition matters more than the tooth count.

Related parts