,

Starter Assembly (4G33-300000F)

Starter Assembly (4G33-300000F). In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Starter Assembly 4G33-300000F for FM WORLD 6.0P

This is the starter assembly part number 4G33-300000F for the FM WORLD 4LZ-6.0P, a 270 × 200 × 100 mm electric cranking motor that weighs 7.15 kg. It turns the engine over fast enough to start, then disengages once the engine is running.

Specifications

Part number4G33-300000F
TypeElectric starter assembly
Size270 × 200 × 100 mm
Weight7.15 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
Availabilityin stock, ready to ship

What this part does

A DC motor drives a small pinion that meshes with the ring gear on the flywheel. When the key is turned, the solenoid first pushes the pinion into the ring gear and then closes the high-current contacts that run the motor. An overrunning clutch on the pinion lets it freewheel if the engine starts and drives back, so the starter cannot be spun at engine speed. The motor only runs for a few seconds at a time, and its job is to supply the cranking torque the engine needs to fire.

Starter fault against a weak battery

A discharged battery or a loose, corroded terminal can produce the same slow cranking or silence as a failed starter. Check the battery state, the main cable and the ground before condemning the motor, since a good starter cannot perform on a poor supply.

Fitting notes

Bolt the starter to the engine so the pinion lines up square with the ring gear, and fit clean, tight terminals on the main cable and the solenoid signal. Tighten the mounting and cable fixings to the service manual values rather than by feel.

Before you fit it

Before fitting, inspect the flywheel ring gear for worn or chipped teeth and examine the pinion for the same damage. A starter that bench-tests fine will still grind if the ring gear is worn, so both parts should be checked together.

Signs this part needs replacing

  • No click and no movement, pointing to the solenoid or its supply
  • A single click without cranking as the contacts fail to close
  • Slow, laboured cranking even with a charged battery
  • Grinding from worn pinion or ring-gear teeth
  • Free-spinning without engine turnover from a worn overrunning clutch
  • Intermittent operation after heat soak or with a bad ground

Compatibility and cross-reference

Where it fits

Mounted on the engine block of the FM WORLD 4LZ-6.0P, with the pinion aligned to the flywheel ring gear.

Confirming the correct part

Confirm by part number 4G33-300000F and the mounting and pinion fit.

Reading the old part

Identify it by the solenoid on top and the drive pinion, and match the bolt pattern and electrical connections rather than relying only on the tag.

Frequently asked questions

Does the starter run the whole time the engine is on?

No. It only runs during cranking; the overrunning clutch disengages the pinion once the engine fires so the motor is not driven at engine speed.

Why does the solenoid click but the engine not turn?

The solenoid can move the pinion while its high-current contacts are burnt or the main feed is poor, so the motor itself never receives enough current to crank.

Related parts