Fuel Injector 4G33TC-251000 for FM WORLD 6.0P
This is the fuel injector part number 4G33TC-251000 for the diesel engine in the FM WORLD 4LZ-6.0P, a 145 × 60 × 43 mm nozzle assembly weighing 0.2 kg. It turns the high-pressure fuel from the pump into a fine spray inside the cylinder.
Specifications
| Part number | 4G33TC-251000 |
|---|---|
| Type | Diesel fuel injector (nozzle) |
| Size | 145 × 60 × 43 mm |
| Weight | 0.2 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
| Availability | in stock, ready to ship |
What this part does
High-pressure fuel arrives through the injector and acts on the needle, which lifts against the spring at the set pressure to uncover the nozzle. Fuel is then forced through the small holes as an atomised spray that mixes with the compressed air and burns cleanly, and the needle closes again the moment the pump stroke ends. The spray pattern and the opening pressure are what separate a good injector from one that merely lets fuel through.
Injector fault against a pump fault
A weak injection pump can give the same misfire or smoke as a bad nozzle because both sit on the same high-pressure circuit. Test the injectors individually first, since a faulty nozzle is far quicker to confirm and replace than the pump.
Fitting notes
Fit clean injectors with new sealing washers and torque to the service manual, keeping the nozzle and fuel line spotless. Any dirt that enters while the line is open will score the needle and spoil the spray.
Before you fit it
Nozzles are checked on a calibrated tester for opening pressure, atomisation and drip, so a unit that dribbles or emits a weak jet should be reconditioned rather than refitted. Because all cylinders share the same wear, a failing injector often points to checking the whole set together.
Signs this part needs replacing
- Rough idle and misfire from a weak or uneven spray
- Loss of power as fuel no longer atomises properly
- Knocking or noise from incorrect injection into the cylinder
- Black or grey smoke from a dripping or blocked nozzle
- Hard starting when the spray pattern has collapsed
- Fuel dilution of the engine oil when the injector leaks
Compatibility and cross-reference
Where it fits
Screwed into the cylinder head of the FM WORLD 4LZ-6.0P, each aimed into its combustion chamber and fed by an injection line.
Confirming the correct part
Confirm by part number 4G33TC-251000, the nozzle fit and the line connection.
Reading the old part
Recognise it by the nozzle tip and spring-loaded body, and match the thread and sealing washer to the old unit.
Frequently asked questions
Why does the injector need to atomise the fuel?
Liquid fuel burns poorly, so the nozzle breaks it into a fine mist that mixes evenly with the compressed air and burns completely rather than leaving smoke or unburnt fuel.
What does a dripping injector do?
A nozzle that does not seal between shots lets fuel dribble into the cylinder, causing smoke, knocking and fuel dilution of the oil instead of a clean timed spray.





