,

Frame Assy,Header (W3.5-01A-01D-01-00)

Part W3.5-01A-01D-01-00. In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Header Frame Assembly (2430 mm) for FM WORLD 4LZ-6.0P

This is the main welded header frame for the FM WORLD 4LZ-6.0P, measuring 2430 x 700 x 800 mm and weighing 104 kg. It carries the cutter, reel and auger and sets the geometry of the whole header.

Frame dimensions

Part numberW3.5-01A-01D-01-00
Part typeWelded header frame assembly
Dimensions2430 x 700 x 800 mm
Weight104 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)

What the header frame carries

Every working part of the header mounts to this frame, so its squared dimensions keep the knife, reel and auger in alignment. A straight frame is what lets the cut material feed without bias.

Telling the two frames apart

The 2430 mm length identifies this frame and separates it from the 2580 mm frame used on the wider header; the part numbers differ, so match the length before ordering.

Fitting the frame

Offer the frame to the feeder mounting and confirm the pivot points line up before tightening. Check the reel, knife and auger seats against their mounts for a square fit.

After mounting, measure the header for square and run the reel and auger slowly, watching for any bind that would point to a twisted mounting face.

When a frame is replaced

  • A cracked or torn weld after a collision
  • A twisted frame that no longer mounts square
  • Enlarged pivot or mounting holes
  • Visible bow along the main beam
  • Reel or auger that binds after correct fitting
  • Rust thinning at a load-bearing section

Ordering details

Mounting: Header frame on FM WORLD 4LZ-6.0P (Ruilong) combine harvesters.

Confirmation: Quote the part number and the 2430 mm length, and give the header width so we confirm the right frame.

Dimensions to match: Check the overall dimensions and the pivot and mounting centres against your removed frame.

Header structure parts

  • Part 2332
  • Buyer questions

    Is this the frame for the wider header?

    No, this is the 2430 mm frame; the wider header uses the 2580 mm assembly under a different part number.

    Can a bent frame be repaired?

    Minor straightening is a workshop decision, but a cracked load-bearing weld or a twisted frame is normally replaced to keep the header geometry true.

    Identification of W3.5-01A-01D-01-00 before ordering

    A header frame is replaced only after impact damage, a cracked weld or distortion; a sound, square frame does not need changing.

    Request a Quote Now