,

Bar,Blade Fixed (W3.5D-01D-01-03-02)

fixed knife bar (knife back beam). In-stock replacement for the FM WORLD header. Order by part number; contact us for exact fitment.

Bar Blade Fixed W3.5D-01D-01-03-02 — 2550 mm

This is the long fixed beam that carries the knife on the FM WORLD 4LZ-6.0P Ruilong header, a 2550 x 40 x 40 mm bar weighing 6.5 kg. The moving sections and their mounts register to this beam, so its straightness and the condition of its mounting faces determine whether the knife can run true across the full 2.55 m width.

Specifications

Part numberW3.5D-01D-01-03-02
TypeFixed knife bar (knife back beam)
Length2550 mm
Section40 x 40 mm
Weight6.5 kg
FitsFM WORLD 4LZ-6.0P (Ruilong) Combine Harvester
AvailabilityIn stock, ready to ship

What this part does

Unlike the sharpened sections, this beam does not cut. It is the rigid reference the knife and wear surfaces align to. A beam that stays straight keeps the cutting register consistent from one end of the header to the other; once it bends, no amount of section or guide adjustment can correct the uneven cut along its length.

Fixed knife beam versus the complete cutter bar assembly

This 6.5 kg beam is the structural knife back on its own, while a complete cutter bar assembly also includes the guards, hold-downs and wear parts. The beam is replaced when only the bar is bent or damaged and the rest of the components are reusable; the full assembly is used when several parts are worn together.

Fitting notes

Mount the beam on clean, square seats and check it is straight before the knife and guards are re-fitted. The beam is a structural reference rather than a moving wear surface, so its mounting seats are kept clean and square so it locates accurately; the knife and its wear surfaces are the parts covered by the service manual’s lubrication schedule.

Before you fit it

Before replacing, check the beam against a straight edge and inspect the guards and wear parts, so the beam is changed only when it is actually bent and not for a worn section.

Signs it needs replacing

  • The beam bent or twisted, producing uneven cutting along the header
  • Mounting faces worn or fretted so the bar cannot locate square
  • Knife sections failing to hold register across the full 2.55 m
  • Cracking at a mounting point rather than a worn cutting edge

Compatibility and cross reference

Models covered

Fits the FM WORLD 4LZ-6.0P Ruilong header; confirm the 2550 mm length and model before ordering.

Confirming the right part

Match the number W3.5D-01D-01-03-02 and the 40 x 40 mm section. This is the fixed beam, not a moving knife.

Reading the old part

2550 mm long with a 40 x 40 mm section and 6.5 kg. It is the 6.0P bar; the 2305 mm bar carrying the W2.5E-01XC-01-03-02 number belongs to the 4.0E, and the two are easy to mix up when both machines are in the same yard.

Questions we are asked about this part

Can a bent knife bar be straightened instead of replaced?

A lightly bent bar may be re-straightened in a workshop if it remains sound, but on a long thin beam that has taken impact, a replacement is the reliable way to restore the cutting register.

Related parts